Essay --

Introduction I chose this bailiwick because I thought it would be fun to pull a quaternary-way assemble that crooks on the same crystalliseheaded. I got the idea to make one when I went online to search for the spotless project idea. I found information roughly a three way light fuddle and clear-cut that this is what I want to do, but to make it more difficult I decided to create a quadruplet way light switch instead. It sounds deal the perfect experiment to try. I felt that if I did this project I would learn more about electricity and the way it works. What is a four way light switch? A four way light switch is an electric switch that uses electricity to power a light bulb that flush toilet be wriggleed on by four different places and not just one or two. The great subject about a four way light switch is that at that place can be more and so one way to turn on one single light. In nightclub to achieve the perfect four ways light switch the four-way swit ch must be in the center of two three light way switches in order for the whole proses to work. A hot cable or cable of 120 fives leave connect from a assault and battery to the light bulb. A wire that is inert will also be connected from the battery to the light bulb. The trio wire cant be neutral or 120 volts (hot wire) and will just float near the 120-volt wire. The third wire that is neither neutral or 120 volts, and 120 volt wire will connect when the switches are turned on and will produce the light. When the light will be turned on the switches should be one circuit in order for the light bulb to turn on and the electrons to break down through the circuit. The switches must be either up or down at the same time in order for the electricity to flow. If one of the switches is up and the other is down the light will not work. If one o... ...ire. When the switch in the center of the hot wire is get acrossed it must touch both the blue and hot wire. To make the cross switch work you must make sure that when you cross the switch in the center of the hot wire and cross the switch in the center of the blue wire that they both are pitiful both wires, only then will the four-way switch work. The switches must be made in a way that they make a end up circuit. The electric cells in the battery will cause the electrons to then travel from the negatively charged electricity to power the light. Once it has touched the string witch is a metal it will conduct electricity. The melting patch of 6,580 degrees F happens inside the light bulb when it is turned on. The electricity then continues to travel through the neutral wire so that the energy can go back to the power source or battery and perform the circuit.